EMT Practice Test

1. Question Content...

---

Question1: An administrator observes that the port1 interface cannot be configured with an IP address. What can be the reasons for that? (Choose three.)

Question2: Refer to the exhibit, which contains a static route configuration.

An administrator created a static route for Amazon Web Services.
What CLI command must the administrator use to view the route?

Question3: Examine the exhibit, which contains a virtual IP and firewall policy configuration.



The WAN (port1) interface has the IP address 10.200.1.1/24. The LAN (port2) interface has the IP address
10.0.1.254/24.
The first firewall policy has NAT enabled on the outgoing interface address. The second firewall policy is configured with a VIP as the destination address.
Which IP address will be used to source NAT the Internet traffic coming from a workstation with the IP address 10.0.1.10/24?

Question4: Which two statements are correct regarding FortiGate HA cluster virtual IP addresses? (Choose two.)

Question5: If Internet Service is already selected as Source in a firewall policy, which other configuration objects can be added to the Source filed of a firewall policy?

Question6: Refer to the exhibits to view the firewall policy (Exhibit A) and the antivirus profile (Exhibit B).


Which statement is correct if a user is unable to receive a block replacement message when downloading an infected file for the first time?

Question7: Which of the following conditions must be met in order for a web browser to trust a web server certificate signed by a third-party CA?

Question8: Which two statements ate true about the Security Fabric rating? (Choose two.)

Question9: Refer to the exhibits.


Exhibit A shows system performance output. Exhibit B shows a FortiGate configured with the default configuration of high memory usage thresholds. Based on the system performance output, which two statements are correct? (Choose two.)

Question10: Which three statements are true regarding session-based authentication? (Choose three.)

Question11: Which two statements are correct regarding FortiGate FSSO agentless polling mode? (Choose two.)

Question12: If Internet Service is already selected as Source in a firewall policy, which other configuration objects can be added to the Source filed of a firewall policy?

Question13: How do you format the FortiGate flash disk?

Question14: View the exhibit.

Which of the following statements are correct? (Choose two.)

Question15: When a firewall policy is created, which attribute is added to the policy to support recording logs to a FortiAnalyzer or a FortiManager and improves functionality when a FortiGate is integrated with these devices?

Question16: A network administrator has enabled full SSL inspection and web filtering on FortiGate. When visiting any HTTPS websites, the browser reports certificate warning errors. When visiting HTTP websites, the browser does not report errors.
What is the reason for the certificate warning errors?

Question17: Why does FortiGate keep TCP sessions in the session table for some seconds even after both sides (client and server) have terminated the session?

Question18: To complete the final step of a Security Fabric configuration, an administrator must authorize all the devices on which device?

Question19: Refer to the exhibit.

Which contains a session diagnostic output. Which statement is true about the session diagnostic output?

Question20: Which three statements about security associations (SA) in IPsec are correct? (Choose three.)

Question21: Which three CLI commands can you use to troubleshoot Layer 3 issues if the issue is in neither the physical layer nor the link layer? (Choose three.)

Question22: Refer to the exhibits.


The SSL VPN connection fails when a user attempts to connect to it. What should the user do to successfully connect to SSL VPN?

Question23: Refer to the exhibit.



The exhibit contains a network diagram, firewall policies, and a firewall address object configuration.
An administrator created a Deny policy with default settings to deny Webserver access for Remote-user2.
Remote-user2 is still able to access Webserver.
Which two changes can the administrator make to deny Webserver access for Remote-User2? (Choose two.)

Question24: Which statement correctly describes NetAPI polling mode for the FSSO collector agent?

Question25: Which two settings can be separately configured per VDOM on a FortiGate device? (Choose two.)

Question26: Refer to the exhibit.


The exhibit contains the configuration for an SD-WAN Performance SLA, as well as the output of diagnose sys virtual-wan-link health-check.
Which interface will be selected as an outgoing interface?

Question27: Which statements are true regarding firewall policy NAT using the outgoing interface IP address with fixed port disabled? (Choose two.)

Question28: Which statement about the policy ID number of a firewall policy is true?
D18912E1457D5D1DDCBD40AB3BF70D5D

Question29: Refer to the exhibit.

Examine the intrusion prevention system (IPS) diagnostic command.
Which statement is correct If option 5 was used with the IPS diagnostic command and the outcome was a decrease in the CPU usage?

Question30: Which of the following are valid actions for FortiGuard category based filter in a web filter profile ui proxy-based inspection mode? (Choose two.)

Question31: An administrator has configured a route-based IPsec VPN between two FortiGate devices. Which statement about this IPsec VPN configuration is true?

Question32: Refer to the exhibit.

Given the interfaces shown in the exhibit. which two statements are true? (Choose two.)

Question33: An administrator has configured the following settings:

What are the two results of this configuration? (Choose two.)

Question34: A network administrator is configuring a new IPsec VPN tunnel on FortiGate. The remote peer IP address is dynamic, in addition, the remote peer does not support a dynamic DNS update service. What type of remote gateway should tie administrator configure on FortiGate for the new IPsec VPN tunnel to work?

Question35: An administrator needs to configure VPN user access for multiple sites using the same soft FortiToken. Each site has a FortiGate VPN gateway.
What must an administrator do to achieve this objective?

Question36: Which two actions can you perform only from the root FortiGate in a Security Fabric? (Choose two.)

Question37: What is the limitation of using a URL list and application control on the same firewall policy, in NGFW policy-based mode?

Question38: Refer to the exhibit.

Which contains a network diagram and routing table output.
The Student is unable to access Webserver.
What is the cause of the problem and what is the solution for the problem?

Question39: Refer to the exhibit.

Based on the raw log, which two statements are correct? (Choose two.)

Question40: What inspection mode does FortiGate use if it is configured as a policy-based next-generation firewall (NGFW)?

Question41: Which two statements are true when FortiGate is in transparent mode? (Choose two.)

Question42: By default, FortiGate is configured to use HTTPS when performing live web filtering with FortiGuard servers.
Which two CLI commands will cause FortiGate to use an unreliable protocol to communicate with FortiGuard servers for live web filtering? (Choose two.)

Question43: Which statement about the IP authentication header (AH) used by IPsec is true?

Question44: Examine the two static routes shown in the exhibit, then answer the following question.

Which of the following is the expected FortiGate behavior regarding these two routes to the same destination?

Question45: Which three security features require the intrusion prevention system (IPS) engine to function? (Choose three.)

Question46: Which two statements are correct about SLA targets? (Choose two.)

Question47: Refer to the exhibit.

A network administrator is troubleshooting an IPsec tunnel between two FortiGate devices. The administrator has determined that phase 1 fails to come up. The administrator has also re-entered the pre-shared key on both FortiGate devices to make sure they match.
Based on the phase 1 configuration and the diagram shown in the exhibit, which two configuration changes will bring phase 1 up? (Choose two.)

Question48: Which three authentication timeout types are availability for selection on FortiGate? (Choose three.)

Question49: Refer to the exhibit.

The exhibits show a network diagram and the explicit web proxy configuration.
In the command diagnose sniffer packet, what filter can you use to capture the traffic between the client and the explicit web proxy?

Question50: View the exhibit.

A
user behind the FortiGate is trying to go to http://www.addictinggames.com (Addicting Games). Based on this configuration, which statement is true?